How Safe Is Your Universal Design AUTO-CAB Cabinet?

In a Word - Very!

	Your AUTO-CAB's smooth operation insures contents will not move and shift.
	The safety plate is used for actuating motion up and down. If the safety plate encounters an obstruction in the down motion, your AUTO-CAB automatically returns to the up position.
	Your AUTO-CAB has a tape switch located on the back side of the face frame and the top of the cabinet box. This is to reduce the possibility of pinching fingers when your AUTO-CAB is moving up into the resting position. When the tape switch is accuated, your AUTO-CAB will move down 3 seconds then stop. To resume motion after the obstruction is cleared; use either the remote, or safety plate and your AUTO-CAB will return to the up position.
	After installation, when first actuated, your AUTO-CAB will go to the up position. If power is cut off and then restored, your AUTO-CAB will always go to the up position when first actuated.
	If your AUTO-CAB is overloaded (100 lbs. total maximum weight of contents) the over current limit circuit disengages the motor to prevent damage to the unit.
	Your AUTO-CAB's failsafe circuits protect against any possible failures (disconnected plugs, loose or broken wires).
	Your AUTO-CAB provides the utmost safety with redundant circuitry in the following modes: UP: Proximity sensor for primary stopping. Timed distance setting in the event of proximity sensor failure. Over current sensor in the event of failure of the proximity sensor and/or the timer. DOWN: Photo eye for primary stopping. Timed distance setting in the event of photo eye failure.